SEVERIN ZT-9751 Instructions For Use Manual page 7

Mincer attachment
Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Familiarisation
1. Worm-drive housing
2. Threaded locking ring
3. Collection container
4. 4-shape slide, for pastries
5. Pastry attachment
6. Worm drive
7. Locking-ring tool
8. Pestle
9. Feeder tray
10. Feeder chute
11. Perforated disc insert
12. 4-bladed knife
13. Cover
14. Slide lock
Important safety instructions
●
The mincer attachment must only be
used with food processor model
KM3882; therefore the KM 3882 safety
instructions also apply.
●
When using the mincer attachment, the
blender bowl (with one of its tools inside)
must be fitted, as the drive head
mounting rotates during operation.
●
Caution: the 4-bladed knife and other
accessory parts are extremely sharp. To
prevent the possibility of severe injury,
take special care when handling or
cleaning this or any other attachment.
●
Should the feeder chute become blocked,
do not use force to push the food down
the chute. Do not, under any
circumstances, use your hands.
●
For safety reasons, use the pestle at all
times when adding food into the feeder
chute. Never use your hands (or other
objects of any kind).
●
Do not let the appliance run empty.
●
Do not touch any moving parts during
operation, as this can be extremely
dangerous.
●
Always switch the appliance off and
remove the plug from the wall socket
before adding, changing or removing any
attachments, or before the appliance is
cleaned. After switching off, always wait
until the motor has come to a complete
standstill.
●
This appliance should only be used with
the attachments provided by the
manufacturer and in accordance with the
purposes described in this manual.
Before using for the first time
Before the mincer attachment is used for the
first time, it should be thoroughly cleaned as
described in the section General care and
cleaning.
Operation
General information
●
Always fit the required attachment
before running the appliance.
●
Always switch the appliance off after use,
and wait until the motor has come to a
complete standstill. Remove the plug
from the wall socket before any
attachments are added or removed.
Worm-drive housing
The worm-drive housing is fitted as follows:
- Press down the slide lock and remove the
cover.
- Press down the slide lock again and fit
the housing onto the shaft in the drive
unit by turning it slightly.
- Release the slide lock once the feeder
chute is vertical. The housing is correctly
fitted and locked when it cannot be
removed by pulling outwards.
A. Mincing meat
- Slide the worm drive into its housing.
- When fitting the 4-bladed knife to the
square end of the worm drive, ensure
that the blade area is still visible.
4