Hi Power Operation; Timer Operation - Toshiba RAS-10JAVP-E Owner's Manual

Hi POWER OPERATION

High power (Hi POWER)
• The Hi POWER (high power operation) mode automatically controls room temperature,
air flow and the operation mode so that the room is quickly cooled in summer and
warmed in winter. ( see page 16.)
Setting Hi POWER mode
a Hi POWER button
Press the Hi POWER button. The Hi POWER mark on the remote control is shown.
Canceling Hi POWER mode
a Hi POWER button
Press the Hi POWER button once again.
The Hi POWER mark on the remote control turns off.
CAUTION
The Hi POWER mode cannot be activated during DRY operation and when the ON
TIMER operation is activated.

TIMER OPERATION

ON timer and OFF timer
Setting the ON Timer
a ON button
ON
Press the ON button. Set the timer to the desired time.
ON
Each time the ON button is pressed, the time changes in ten minute increments.
Holding down the ON button changes the time in one hour increments.
b SET
button
SET
Press the SET button to set the timer.
SET
The timer time is displayed, and the timer starts.
c CLR
button
CLR
Press the CLR button to cancel the timer setting.
CLR
Setting OFF Timer
a OFF
button
OFF
Press the OFF button.
OFF
Set the timer to the desired time.
Each time the OFF button is pressed, the time changes in ten minute increments.
Holding down the OFF button changes the time in one hour increments.
b SET button
SET
Press the SET button to set the timer.
SET
The timer time is displayed, and the timer starts.
c CLR
button
CLR
Press the CLR button to cancel the timer setting
CLR
.
CAUTION
• When you select timer operation, the remote control automatically transmits the timer signal to the indoor unit at the
specified time. Therefore, keep the remote control in a location where it can transmit the signal to the indoor unit properly.
• If you do not press the SET
Once you select timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions as if you pressed the
control.
You cannot set the timer when the clock display is flashing.
Follow the instructions in the section "Setting the clock" on page 6 to set the clock, and then set the timer.
button within 30 seconds after setting the time, the setting will be cancelled.
SET
11
PAP AUTO
TEMP
MODE PRESET
a
MEMO
HiPOWER ECO
1 . 3 . 5 . 9H
SWING FIX FAN SLEEP
CLR SET
OFF
ON
FILTER
CLOCK
RESET
CHECK
PAP AUTO
TEMP
MODE PRESET
HiPOWER ECO MEMO
1 . 3 . 5 . 9H
SWING FIX FAN SLEEP
b
CLR SET
c
ON OFF
FILTER
CLOCK
a
RESET
CHECK
or button of the remote
ON OFF
EN