Toshiba CARRIER RAV-SP180CT-UL Installation Manual page 26

Under Ceiling Type
6
Procedure
If there is other indoor unit to be changed, repeat
2 5
procedure to
When the above setup has finished, push
select the indoor UNIT No. before change of setup,
specify CODE No. [12], [13], [14] in order with temp.
setup /
contents.
Address change check Before change:
[3-3-1] → After change: [2-2-2]
Pushing button clears the contents of which setup
was changed.
(In this case, procedure from
Indoor UNIT No. before setup change is displayed.
7
Procedure
After check of the changed contents, push
(Setup is determined.) When pushing
display disappears and the status becomes the usual
stop status. (When pushing
from the remote control is not accepted for approx.
1 minute.)
* If the operation from the remote control is not
accepted even 1 minute or more passed after
pushing button, it is considered that the address
setup is incorrect.
In this case, the automatic address must be again
set up.
Therefore repeat procedure of the setup change
from the Procedure
To recognize the position of the
corresponding indoor unit though the
indoor UNIT No. is known
Check the position during operation stop.
(Be sure to stop operation of the set.)
25-EN
to change the setup.
buttons, and then check the changed
2
is repeated.)
button the operation
1
.
to
1,3
Procedure
Push simultaneously
or more.
After a while, the display part flashes and the display
appears as shown below.
In this time, the position can be checked because fan
and louver of the indoor unit operate.
• For the group control, the indoor UNIT No. is
displayed as [
indoor units in the group control operate.
Check the displayed CODE No. is [01].
• When the CODE No. is other than [01], push
button to erase the display and repeat procedure
from the first step.
(After pushing
control is not accepted for approx. 1 minute.)
button.
button, the
Procedure
In the group control, every pushing
indoor UNIT No. in the group control is displayed in
order.
In this time, the position of the indoor unit can be
confirmed because only fan of the selected indoor unit
operate.
(For a group control, No. of the firstly displayed indoor
unit becomes the header unit.)
Procedure
After confirmation, push
to the usual mode.
When pushing
the status becomes the usual stop status.
(When pushing
remote control is not accepted for approx. 1 minute.)
– 25 –
Installation Manual
1
+ buttons for 4 seconds
] and fans and louvers of all the
button, operation of the remote
(* Display changes according to
the model No. of indoor unit.)
2
3
button to return the mode
button, the display disappears and
button the operation from the
1
2
button, the