Table of Contents
Advertisement
CAUTION
Do not eat or swallow toner.
Keep toner (used or unused) and toner cartridge out of reach of children.
Do not put an object on the right cover when it is open.
Protect the equipment from dampness or wet weather, such as rain, snow, and so on.
Unplug the power cord from the wall outlet before you move the equipment. While
moving the equipment, you should take care that the power cord will not be damaged
under the equipment.
When you disconnect the power plug from the wall outlet, always pull the plug (not the
cable).
Do not allow paper clips, staples, or other small metallic objects to fall inside the
equipment.
For environmental reasons, do not dispose of the equipment or expended supply
waste at household waste collection points. Disposal can take place at an authorized
dealer or at appropriate collection sites.
The inside of the machine becomes very hot. Do not touch the parts with a "v" label
(means hot surface). Touching a part with a "
" label (means hot surface) could
result in a burn.
The fusing unit becomes very hot. When installing the new fusing unit, turn off the
printer and wait about 30 minutes. After that, install the new fusing unit. Not waiting for
the unit to cool down can result in a burn.
Do not pull out the fusing unit forcefully. It may cause the unit to fall and result in an
injury.
When touching the fusing unit, do not touch any areas other than the handle as it may
cause a burn.
When removing misfed paper, do not touch the fusing unit because it could be very
hot.
To prevent an injury, this printer should be lifted by at least two people.
The printer weights approximately 31.5 kg (69.4 lb). When moving the printer, use the
inset grips on both sides, and lift slowly. The printer will break or cause injury if
dropped.
Before installing options, the machine should be turned off and unplugged for at least
half an hour. Components inside the machine become very hot, and can cause a burn
if touched.
Lifting the paper feed unit carelessly or dropping it may cause an injury.
Lifting the duplex unit carelessly or dropping it may cause an injury.
Do not touch the inside of the controller board compartment. It may cause a machine
malfunction or a burn.
Keep the machine away from humidity and dust. A fire or an electric shock might
occur.
Place the machine on a strong and level surface. Otherwise, the machine might fall
and result in an injury.
Safety-3
Advertisement
Table of Contents
