Stove Specifications - Lennox Traditions Freestanding P11 Installation Instructions Manual

SPECIFICATIONS - Model Profile 20-Freestanding
Approx. Sq. Ft Heat
Capacity
Flue Size
Width, Overall
Depth, Overall
Height
Floor to Rear
Flue Center
Facing back of unit,
outside edge of left side
to center of rear
flue outlet
Floor to Rear
Outside Air Inlet
Facing back of Unit
outside edge of right side
to center of air inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Bum time
Fuse
Heat Input {BTU's per hour)
Overall Efficiency
Emissions
Shipping Weight
Room Fan
Auger Motor
Draft Fan
Options
•
Dimensions shown are approximations only(+/- ¼")
- Square footage heating capacities are approximations only. They will
vary depending upon the level of insulation, climate, house design,
ceiling height, ambient outside temperatures and how the stove is
operated.
■ Non-combustible floor protection must be used when installed on
carpet (see Floor Protection, page 11 ).
♦ Fuel delivery and bum times will vary depending on size and
type of fuel used. Estimated heat input based on fuel value of
8500 BTU per lb.
Up to -1200 sq. ft.
3" Rear
22 1/4"
22 3/4"
28 5/8"
11 1/4"
6 1/2"
12"
* 6 3/4"
■ Non-combustible floor protection
must fully cover the area beneath the
appliance and extend 6" to the front of
the face of the stove and 6'' beyond
both sides and back of appliance.
Fastfire Self Igniter
Wall Thennostat (wire included)
55 lbs.
♦ 15-37 hours
5 amp, 250 volt, 3AG
♦ 13,000-32,000 BTU/hr
75-81%
♦ 0.9 grams/hr (varies w/size
and type of fuel) EPA exempt.
215 lbs.
150 CFM; .8 amps,
2175 rpm
1 RPM; .4 amps
95 CFM: 1.0arrips,
288 ? rpm
Nickei or "Geld Trim Kits
Log Set
Page 29
t------22114
28 5/8"
D
,·
'"
----