Preparing Your Epic Stove For Installation; Dimensions - Lennox Elite Series Installation And Operation Manual

Preparing Your Epic™ Stove For Installation
Read all instructions before beginning your installation. If instructions
have not been read carefully, your installation could void your warranty
and may create a serious fire, health, or other safety hazard.
The Lennox Hearth Products warranty will be voided if one of the fol-
lowing occurs:
• Installation of any damaged stove or vent system component.
• Unauthorized modification of the direct-vent system.
• Installation other than as instructed by Lennox Hearth Products,
Security™ Chimneys, or Simpson Dura-Vent.
• Installation of any stove or vent system component not manu-
factured or approved by Lennox Hearth Products, Security™
Chimneys, or Simpson Dura-Vent.
When planning the installation for your Epic gas stove, it's necessary to
consider the following:
• Where the unit is to be installed
• The vent system configuration to be used
• Gas supply (NG or LP)
• Electrical wiring
• Optional accessories (door trim assembly and wall-mounted or
remote thermostat)

Dimensions

The gas line attaches to the gas valve at the lower left corner at the
back of the stove. Test all gas connections for leaks with a gas leak test
solution.
Figure 1
Figure 2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Top View
23-1/2"
23-1/2"
(597mm) (597mm)
Front View
23-1/2"
23-1/2"
(597mm)
(597mm)
17"
17"
(432mm)
(432mm)
31-1/4"
31-1/4"
(794mm)
(794mm)
7