Troubleshooting - Lennox Traditions Freestanding P11 Installation Instructions Manual

Freestanding and insert pellet fired stoves
Table of Contents

Advertisement

Unplug Stove Before Performing any Maintenance work
PROBLEM
Fire burns with a lazy
orange flame. Pellets build
up in the grate and the win­
dow gets sooted up.
Fire goes out or stove shuts
down automatically

Troubleshooting

Qualified Technicians Only
There is insufficient combus­
tion air.
The hopper is empty
Pellets are not feeding.
The high limit temperature
switch has tripped.
Page 33
Remove any clinkers or ash from
the bottom of the grate that might
be obstructing the primary air
holes.
Change to a better grade of fuel if
necessary.
Check that the damper has been
opened enough for the amount of
fuel feed.
Check that the heat exchange
tubes are not coated with ash.
Clean internal exhaust ducts.
Check gasket seal around the door.
Use a thin strip of paper, 1 in. wide.
Open the door and close it on the
paper strip. A slight friction should
be felt when the paper strip is
pulled. Repeat this process at vari­
ous locations around the door gas­
ket. Replace the door gasket if
necessary
Check for blockage in the air inlet
tube or exhaust pipe. Clean as nec­
essary.
Close ash slide plates.
Have your Hearth Trends dealer
·
check your combustion blower.
Refill hopper.
See (Pellets will not feed)
next page.
Allow stove to cool for 1 hour and
re-light. If the stove has been

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents