Lennox Traditions Freestanding P11 Installation Instructions Manual page 33

SPECIFICATIONS - Model Profile 30-lnsert
Approx. Sq. Ft Heat
Capacity
Flue Size
Width, Overall front (w/o shroud)
Width, Overall back (w/o shroud)
Depth, Overall (w/o shroud)
Height, rear (w/o shroud)
Height, front (w/o shroud)
Floor to Rear
Flue Center
Fireplace Face to Rear
Flue Outlet Collar
Dimensions into Fireplace
Minimum Height
Minimum Width
Minimum Depth
Facing Back of Unit,
Right Outside Edge of Unit
to Center of Rear Flue Outlet
Floor to Rear
Outside Air Inlet
Facing Back of Unit,
Right Outside Edge of Unit
to Center of Air Inlet
Floor Protection
Requirements
Standard Features
Hopper Capacity
Bum time
Fuse
Heat Input (Max.)
Overall Efficiency
Emissions
Ship Weight
Room Fan
Auger Motor
Draft Fan
Options
•
Dimensions shown are approximations only(+/- ¼")
- Square footage heating capacities are approximations only. They will
vary depending upon the level of insulation, climate, house design,
ceiling height, ambient outside temperatures and how the stove is
operated.
■
Non-combustible floor protection must be used when installed on
carpet (see Floor Protection,
♦
Fuel delivery and burn times will vary depending on size and
type of fuel used. Estimated heat input based on fuel value of
8500 BTU per l b.
Up to -1500 sq. ft.
3" Rear
26"
24 1/8"
26 1/4"
19 15/16"
23 5/8"
9 1/4"
13 1/4"
20 1/8"
24 3/8"
13 1/2"
5"
2 1/8"
*12 7/16"
■ Non-combustible floor protection
must fully cover the area beneath the
appliance and extend 6" to the front of
the face of the stove and 6" beyond
both sides of appliance.
Fastfire Self Igniter
Wall Thermostat (wire included)
50Ibs.
♦ 10-45 hours
5 amp, 250 volt, 3AG
♦ 14,000-39,000 BTU/hr
81%
♦ 0.9 gram/hr (varies w/size
and type of fuel) EPA certified.
__ • lb§.
150 CFM; .8 amps, 2175 rpm
1 RPM; .4 amps
95 CFM: 1.0amps, 2880 rpm
Nickel or Gold Trim Kits
Log Set
page 11 ).
-----24 1/8"----�
1 -
_J= 13" --.
23 5/8"
I
Page 32
,.,_511
12 1/2"
26 1/4"-----
13 1/4" -l