Setting Up The Floorstand Model; Installing The Stabilizers - Fujitsu PRIMERGY TX1320 M4 Operating Manual

5.3

Setting up the floorstand model

if you are using a PRIMERGY TX1320 M4 server horizontally, skip this section
and continue reading ar section
page 62.
V
CAUTION!
Note the safety instructions in chapter
page 41.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see
Ê Set up the server.
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê If applicable, install the stabilizers, see section
page 59.
Ê Connect the devices to the server, see section
server" on page 64
on page 63.
Ê Connect the server to the mains, see
page 65.
5.3.1

Installing the stabilizers

V
CAUTION!
If the server is positioned vertically, the stabilizers must be attached!
The stabilizers must be attached in the correct direction.
TX1320 M4
"Positioning the server horizontally" on
section"Unpacking the server" on page
and section "Notes on connecting/disconnecting cables"
section"Connecting the power cord" on
Operating Manual
"Important information" on
"Installing the stabilizers" on
"Connecting devices to the
Starting up
58).
59