Table of Contents
Advertisement
removing the power cord, pull the latch toward yourself, turn the connector counterclockwise, and remove it.
WARNING
You must use the included power cord. Do not use the included power cord with any other product.
Doing so may cause malfunction, overheating, and fire.
NOTICE
• When this product is connected to an AC outlet, it is in standby mode, and a small amount of current
is flowing. If you will not be using this product for an extended period of time, be sure to disconnect
the power supply plug from the AC outlet.
• Position the power cord so that the rear exhaust does not contact it directly. The temperature of the
rear exhaust might cause the power cord to deform.
⑩ Exhaust vent
This is an exhaust vent for the cooling fan. Because warm air is expelled through this vent, take care that it is not
blocked by an obstruction.
⑪ [SPEAKERS] A/B/C/D connectors
These are the output connectors to the speakers. There are the following two types of connector.
WARNING
Do not touch the pins of unused channels, or allow them to short.
High voltage is present even at unused pins.
● PC-D series
Four Speakon output jacks (NL4) are used to connect speakers.
The outputs of this product can be bridged in pairs of two channels.
There are no dedicated outputs for use in bridge mode. For the pin assignments, refer to
● PC-DI series
This product uses Euroblock connectors (7.6 mm 8-pin) for speaker connections.
The outputs of this product can be bridged in pairs of two channels.
There are no dedicated outputs for use in bridge mode. For the pin assignments, refer to
⑫ Dante [PRIMARY]/[SECONDARY] ports
This is an etherCON (RJ-45) port for connection to a CL-series unit or other Dante device via an Ethernet cable
(CAT5e or better is recommended). For the PC-D series, use RJ-45 connectors that comply with Neutrik
Corporation's etherCON CAT5. For the PC-DI series, use RJ-45 connectors.
NOTE
• To prevent electromagnetic interference, use STP (Shielded Twisted Pair) cables. For STP cables,
use conductive tape to securely connect the metal portion of the connector to the shielded portion
of the cable.
PC412-D PC412-DI PC406-D PC406-DI Owner's Manual | 7
2. Panel descriptions
"Speaker
connections."
"Speaker
connections."
Advertisement
Table of Contents
