Kohler K-11344 Installation And Care Manual page 13

x4
10. Install the Bath
Turn the bath shell upside down on the saw horses.
Make sure that all the drain connections are secure.
Cut the cable ties securing the PVC blower hose and keypad cable.
Position the shroud on the bath so the edges of the shroud rest inside the bath shell. Make sure that
the blower hose and keypad cable are accessible from the bottom of the shroud.
Secure the shroud to the bath with a screw at each corner. Do not overtighten.
Apply a bead of 100% silicone sealant around the perimeter of the bottom of the shroud.
Make sure that the foot clips are not in the locked position.
Move the bath close to the installation location.
Cement the PVC blower hose connection to the PVC piping.
Route the keypad cable under the floor and to the blower motor area.
Carefully set the bath into position while feeding the PVC pipe into the hole in the floor.
Make sure that the posts on the bath frame fit into the four foot clips, and that the drain fits into the
drain pipe.
Check for solid fit (no rocking) and a 24-1/8" (613 mm) rim corner height to the finished floor.
If necessary, lift the bath and adjust the four posts as needed to ensure a distance of 24-1/8" (613
mm) from the finished floor to the top of each bath rim corner. Adjust the bath levelers as needed.
Make sure that the bath levelers and bath feet are tight.
Kohler Co.
100% Silicone
Sealant
24-1/8"
(613 mm)
13
x4
x4
Post
x2
Bath
Leveler
1220597-2-F