HP AlphaServer ES80 Installation Manual page 37

Refer to Figure 3–7 and install the cable support rack and drawer latches as follows:
1. Slide the I/O drawer out slightly so you can easily access the back of the drawer.
2. Insert the tab at the bottom of the cable support rack into the hole at the rear of the
I/O drawer
3. Align the eyelets on the two sides of the cable support rack with the pre-tapped
holes in the I/O drawer. Also align a drawer latch with this hole on the outside of
the I/O drawer. Use an M4 x 0.7 x 8mm screw to attach both the drawer latch and
one side of the cable support rack to the I/O drawer.
4. Repeat steps 2 and 3 for the other side of the I/O drawer.
Cabling 3-13