Preparations; Settings; Cautions During Connection; Steps For Connecting - Korg Pearl e/MERG MDL1 Quick Start Manual

Settings

Cautions during connection

• Use the dedicated breakout cable that is included, in order
to connect the module to the PureTouch Pad.
• Before connecting this instrument to the pads, place this
instrument on a rack or stand.
• Connect the additional pads 1/2/3 to the ACC IN (TOM4/
ACC1, ACC2, ACC3) jacks on the module using the cables
included with the additional pads (optional) or a commer-
cially available 6.3 mm stereo phone plug (TRS) cable.
• Make sure that the cable is long enough when connecting.
• Arrange the cables so that they do not get pinched by the
pedal or stand.
Connections
Included AC adapter
Mixer
Powered monitor speaker
Headphones

Preparations

Steps for connecting

1. Mount each pad and the module on the rack.
Refer to "How to Assemble"(a separate sheet).
2. Connect the included breakout cable to the module.
3. Connect each cable coming from the breakout cable to
each pad.
While checking the marker on each cable, connect each
pad carefully without getting the connections mixed up.
4. Connect the included AC adapter, a powered monitor
speaker, stereo amp, or mixer to this module.
(See "Connecting the included AC adapter", p.8)
(See "Connecting audio devices", p.8)
Audio player
HH
HHC
SN-A
SN-B
The cables connected to the HH (hi-hat) and KICK (bass
drum) supply power to the light and to the controller.
Be careful not to connect other products besides the
specified pad. Doing so may cause instrument failure. Be
sure to connect the cable before turning on the power.
Breakout cable
RD-B
CR
TM1
TM2
TM3
KICK
Additional pad 3
Additional pad 2
Additional pad 1
RD-A
7