Advertisement
8. Install the Push Buttons
Remove the tape covering the push button on the tank cover, and
remove the protective pad. Discard the pad.
Carefully set the cover in position on the tank.
Press the large push button in the center of the cover, and use your
fingers to carefully pull out and remove the small push button. Then
pull out and remove the large push button.
Press the large push button onto the larger diameter rod, and the
small push button onto the smaller rod.
Insert the rods into the side holes in the push button housing in the
center of the cover. Press down on the push buttons until they click
into place in the housing.
1066117-X2-B
8
Kohler Co.
Advertisement
