Table of Contents
Advertisement
Access Modular Controller 2
4.8
Ethernet Host Interface
The AMC2-4R4 offers a 10/100 Mbit/s Ethernet auto-sensing interface to connect to a local
area network or host computer.
A complete connection diagram of the Ethernet host interface is shown in chapter Connecting
Diagrams, page 41.
Notice!
After connecting a new AMC2 device to a network using DHCP, it can take some time before
the new AMC2 device is recognized by the remote server.
You can accelerate this process by running the following command:
ipconfig /flushdns
This makes the AMC2 device immediately available by its name.
Bosch Access Systems B.V.
Installation manual
Installing | en
21
2020-01 | V02 |
Advertisement
Table of Contents
