Power Mode, Factory Reset - McIntosh C2700 Owner's Manual

Power Mode
The C2700 incorporates an Auto Off Feature, which
automatically places the Preamplifier into the Power
Saving Standby/Off Mode. This occurs approximately
30 minutes after there has been an absence of user ac-
tivity (includes changes to any of the Operation Func-
tions such as source selection, volume adjustment,
etc.) or absence of an audio signal. If it is desirable to
disable the Auto Off Feature perform the following
steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until "SETUP: Auto
Off, Enabled" appears on the Information Display.
Refer to figure 52.
SETUP: Auto-Off
Enabled
Figure 52
3. Rotate the VOLUME (ADJUST) Control to select
"Disabled". Refer to figure 53.
SETUP: Auto-Off
Disabled
Figure 53
20
Factory Reset
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until "FACTORY RE-
SET, (Hold INPUT)" appears on the Information
Display. Refer to figure 54.
FACTORY RESET
(Hold INPUT)
Figure 54
3. Press and hold in the INPUT Control until "FAC-
TORY RESET, In Progress!" appears on the Infor-
mation Display, then release the INPUT Control.
Refer to figures 55 and 56.
FACTORY RESET
In Progress!
Figure 55
FACTORY RESET
Completed!
Figure 56
4. Press the Front Panel STAND/BY Push-button to
switch the C2700 on.
Setup, con't