Table of Contents
Advertisement
Procedure
1. The enclosure has a top cover that can be raised. It is equipped with a gas shock
2. To open the cover, release the locks with a double-bit key (included in the enclosure).
3. Make sure that the installed cables and lines are securely installed and check that there
4. Route the cables and lines from below through the glands designated for these and
5. Install and connect the power supply cable, the bus cable and the signal lines according
6. If you replace installed components, follow the instructions in the manufacturer's
Wall-mount enclosure 6DL2804-0xxxx
Hardware Installation Manual, 08/2009, A5E00378691N-02
absorber and can be opened without force.
Hold the cover firmly while unlocking to make sure that this does not spring up to quickly
because of the pressure of the steam.
is sufficient strain relief. It is not permitted to use the cable entry as strain relief.
tighten the clamping screw of the gland to the torque specified in the manufacturer's
instructions.
to the standard EN 50020. In hazardous areas, the installation regulations according to
EN 60079-14 and the national regulations must also be observed.
description of the device.
Mounting
4.2 Mounting the enclosure
17
Advertisement
Table of Contents
