Connection; Connect The Lan Cable To The Ipc (Premounted Version Of The Connectivity Module); Connection (Connectivity Module Version That Can Be Retrofitted) - Siemens SINAMICS CONNECT 500 Operating Instructions Manual

Connection

6.1 Connect the LAN cable to the IPC (premounted version of the
connectivity module)
For operation, connect the connectivity module with your company network and the Internet via
the LAN interface of your IPC.
Note
When carrying out any work, carefully observe the five safety rules (Page 8).
Procedure
1. Open the control cabinet of the converter.
2. In the control cabinet, locate where the IPC is installed.
3. Route the LAN cable into the control cabinet.
4. Route the LAN cable to the IPC.
Note
Maintain the permissible cable bending radius. Route the cable so that it does not come into
contact with any sharp edges.
5. Connect the LAN cable to interface "X1 P1" of the IPC.
6.2

Connection (connectivity module version that can be retrofitted)

The instructions to mount and install the connectivity module version that can be retrofitted are
provided in the Internet (https://support.industry.siemens.com/cs/ww/en/ps/25520).
SINAMICS CONNECT 500
Operating Instructions, 10/2019
①
Interface X1 P1
6
25