Advertisement
Trike Assembly
The Trike comes either fully or partially assembled. Follow the instructions below
for Trike Assembly. If equipped, the Lights and Sound unit will be installed on the
Handlebars.
3
6
12
16
CAUTION:
• Ensure Handlebars and Fork turn smoothly in both directions and are not loose.
• Ensure front Wheel and Pedals rotate smoothly.
4
Fork, Handlebars and Lights and
1
Sounds unit (if equipped):
1. Place the Fender (16) over the fork
(13) as shown.
2. Slide the Fork assembly into the
Frame (12).
3. Place Cap (3) onto Handlebar (1).
4. Make sure Spacer (6) is in place
over Fork Tube (13).
5
5. Install Handlebar (1) into Fork (13)
so that screw holes are aligned.
6. Install Screw Set (5) through
Handlebar and Fork holes. Tighten
securely.
7. Slide Cap (3) down until the tabs
snap in place.
13
Advertisement
