Agilent Technologies M1205A V26 Service Manual page 50

$JLOHQW 0$ 99 6HULHV 6HUYLFH *XLGH
7HVW %ORFN 7HVW RU ³,QVSHFWLRQ´ WR 3HUIRUP
1DPH
3HUIRUPDQFH 6WHS  Connect the patient simulator to the ECG
7HVW (&*
input and the defibrillator to the monitor
6\QF
ECG-Sync output.
6WHS  Configure the patient simulator as
follows:
ECG sinus rhythm
HR = 100 BPM (Amplitude 1 mV)
6WHS  Switch defibrillator to simulation mode.
6WHS  Check that the marker pulse is displayed
before the T-Wave begins.
3HUIRUPDQFH 6WHS  In Monitoring mode connect the 6HQVRU
7HVW %,6 6LPXODWRU (for maximum usage please
refer to the documentation delivered with
3,&'6& 7HVW
the Sensor Simulator) to the Patient
Interface Cable
6WHS  Enter the BIS Task Window by pressing
0RGXOH 6HWXS, followed by %,6.
6WHS  Start Impedance Check by pressing 6WDUW
&KHFN. This brings up the BIS Cyclic
Check TaskWindow. Check the displayed
results.
3HUIRUPDQFH 6WHS  Enter Service Mode
7HVW %,6 6WHS  Enter the BIS Task Window by pressing
FRQWLQXHG 0RGXOH 6HWXS, followed by %,6.
6WHS  StartTest by pressing 7HVW '6&. Check
'6& 7HVW
the displayed results.
 7HVWLQJ 0DLQWDLQLQJ WKH $JLOHQW 99 6HULHV
7DEOH  7HVW DQG ,QVSHFWLRQ 5HTXLUHPHQWV
([SHFWHG 7HVW 5HVXOWV
Marker pulse is displayed
before T-Wave begins.
Electrode 1: 4-6 kΩ
Electrode 2: 8-12 kΩ
Electrode 3: 1-3 kΩ
Module: 7HVW SDVVHG
BIS engine:7HVW SDVVHG
DSC: 7HVW SDVVHG
:KDW WR 5HFRUG
RQ 6HUYLFH
5HFRUG
7KHVH UHVXOWV
GR QRW KDYH WR
EH UHSRUWHG
7KHVH UHVXOWV
GR QRW KDYH WR
EH UHSRUWHG
7KHVH UHVXOWV
GR QRW KDYH WR
EH UHSRUWHG