Table of Contents
Advertisement
$JLOHQW 0$ 99 6HULHV 6HUYLFH *XLGH
Troubleshooting NBP Problems
$JLOHQW XVHV
To ensure accurate NIBP measurements, the NBP plug-in module can be calibrated. Agilent
LQYDVLYH SUHVVXUH DV
recommends that the module is calibrated once every 12 months.
UHIHUHQFH IRU 1%3
'LDVWROLF
This section describes how to troubleshoot and correct faults associated with the NBP module.
PHDVXUHPHQWV FDQ
The procedures for recognizing, isolating, and correcting faults with this module are as follows:
EH XS WR PP+J
ORZHU WKDQ SUHVVXUH
• Identifying a problem based on visual indications or repeated INOPS.
PHDVXUHG E\
DXVFXOWDWRU\
.RURWNRII PHWKRG
• Checking the NBP task window for specific error messages and performing the corrective
actions suggested in the table given with this module.
• Calibrating the module as required.
7R 7URXEOHVKRRW WKH 0RGXOH
5-12 Troubleshooting Plug-in Modules
If QHLWKHU QXPHULFV QRU D " are displayed for the NBP module, perform the
following actions:
6WHS Make sure the NBP parameter is turned on. Turn it on, if it is not.
6WHS Make sure the NBP numeric is turned on. Turn it on, if it is not.
6WHS Make sure you don't have more than one NBP module plugged into the module
racks you are using. If more than one NBP module is plugged in, the
supernumerary modules are ignored and should be removed.
6WHS Check the connection on the module and the rack interface.
Unplug and re-plug the NBP module and check if the green LED on the NBP
module lights up after re-plugging. If it does not, proceed with the following:
Put the NBP module into another slot and check the LED once again. If it lights
up now, the connector for the previous slot is faulty and the rack needs to be
replaced. If it does not, proceed with the following:
1RWH WKLV SURFHGXUH DSSOLHV RQO\ IRU VHWXSV LQ ZKLFK WKH 1%3 PRGXOH LV
ORFDWHG LQ D 6DWHOOLWH 5DFN ,I WKLV GRHV QRW DSSO\ IRU \RXU VLWXDWLRQ SURFHHG
ZLWK
Replace the cable from the Satellite Rack to the function box. Again unplug
and re-plug the NBP module and check if the LED lights up. If it does not,
proceed with the following:
Advertisement
Table of Contents
Troubleshooting
