Safety 1st Grow and Go 3-in-1 Instructions Manual page 23

2. Place Child Restraint
Rear Facing in Back
Seat
For children who cannot sit up
unassisted, the level line on shell
MUST
For children who can sit up
unassisted, you may rotate the
child restraint to be more upright.
3. Route Vehicle Lap
or Lap/Shoulder Belt
Through Rear-
Facing Belt Path
Review pages 29-30 and your
vehicle owner's manual to
determine what kind of vehicle
belts you have.
4. Reach Under Pad and
Pull Vehicle Belt Across
the Shel
1
2
Do not twist belt. Belt
in front of buckle strap.
You
buckle slot. Do not place belt over
child's legs. Buckle vehicle belt.
39
4358-6653 Grow and Go 3 in 1.indd 45-46 4358-6653 Grow and Go 3 in 1.indd 45-46
be parallel with the ground.
l
MUST be
MUST use the 1st or 2nd
5. Tighten Belt
Place hand in child restraint.
Firmly push down and towards
the vehicle seat back while pulling
shoulder belt or free end of lap belt
to tighten.
6. Check Belt Tightness
Hold child restraint at the belt
path with your weakest hand.
Push and pull from side to side.
If it moves more than 1 in. (2.5
cm), try reinstalling the child
restraint, try another seating
location, or try using the LATCH
belt instead if available.
7. Secure Child in Child
Restraint
Recheck the level line.
Repeat steps 2-6 if not
reclined correctly.
NOTE: You may need to place
a large rolled towel(s) or foam
pool noodle(s) under front of
child restraint to help achieve the
correct recline angle.
Check often to be sure
padding is still in place and the
belt is tight.
4/15/15 8:48 AM 4/15/15 8:48 AM
40