Safety 1st Grow and Go 3-in-1 Instructions Manual page 21

7. Place Child Restraint
Rear Facing in Back
Seat
For children who cannot sit up
unassisted, the level line on shell
MUST
For children who can sit up
unassisted, you may rotate the
child restraint to be more upright.
8. Hook LATCH to Vehicle
Anchor in Seat Bight
9. Tighten Belt
Place hand in child restraint.
Firmly push down and
towards the vehicle seat back
while pulling free end of belt to
tighten.
It may be easier to pull pad away
from shell and tighten the belt
through the belt path opening as
shown.
35
4358-6653 Grow and Go 3 in 1.indd 41-42 4358-6653 Grow and Go 3 in 1.indd 41-42
be parallel with the ground.
10. Check Belt Tightness
Hold child restraint at the belt
path with your weakest hand.
Push and pull from side to side.
If it moves more than 1 in. (2.5
cm), try reinstalling the child
restraint, try another seating
location, or try using the vehicle
belts.
11. Secure Child in Child
Restraint
Recheck level line.
Repeat steps 7-10 if not reclined
correctly.
NOTE: You may need to place
a large rolled towel(s) or foam
pool noodle(s) under front of
child restraint to help achieve the
correct recline angle.
Check often to be sure padding is
still in place and the belt is tight.
continued on next page
4/15/15 8:48 AM 4/15/15 8:48 AM
36