Table of Contents
Advertisement
S6S Home pro steam cleaner UG 28.02.13_User guide 07/03/2013 11:41 Page 7
Operation
Steam cleaning hard floors
WARNING: Never leave the steam cleaner floor head in one spot on any surface for an extended period of time with a damp or wet
pad attached as this may damage the floor surface. Your steam cleaner should only be used on sealed floors including tiles, lino,
wood flooring and laminate.
WARNING: To reduce the risk of personal injury, unplug the steam cleaner when assembling the accessories.
Do not operate the steam cleaner without water in the clean water tank.
Plug into mains, turn on and press power
button on.
After approximately 12 minutes
the
Green LED
will illuminate showing
steamer is ready to use.
When cleaning sealed hard floors, move the
steamer slowly backwards and forwards
paying particular attention to high traffic
areas. Squeeze/release trigger as required.
vax.co.uk
Ensure steam handle safety latch is on.
Release steam handle safety latch.
Rotate variable steam dial to adjust pressure.
Orange LED
will illuminate when water
is heating.
To produce steam, squeeze the trigger in
short bursts. To prevent overly wetting
floors, do not hold down continuously.
1 x 1.4L water tank =
40 minute steaming time (approx)
Orange
light = water heating
Green
light = steamer ready to use
No green light = water heating to
maximum temperature.
(Note: you can still use your steamer at
this time).
If during use the green light switches off,
this means the steamer is heating up to
maximum temperature. The green light
will re-appear when it has heated back
up to maximum temperature.
7
Advertisement
Table of Contents
