Change Lan Settings - TP-Link RE300 User Manual

Chapter 5
5. Click Save.
• To enable or disable the extended network:
1. Go to Settings > Wireless
2. Extended networks are enabled by default. If you want to disable the wireless function
of a certain band, just clear the
of this band will be invalid.
3. Click Save.
• To change the wireless network name (SSID):
1. Go to Settings > Wireless
2. Create a new SSID in
case-sensitive.
3. Click Save.
Note:
If you have changed the wireless settings via a wireless device, you will be disconnected after the settings are applied.
Please write down the new SSID for future use.
• To hide the SSID of the extended network:
1. Go to Settings > Wireless
2. Select Hide SSID broadcast, and the corresponding SSID will not be displayed when
wireless devices scan for local wireless networks. You need to manually enter the
SSID to join the network.
3. Click Save.
5 3

Change LAN Settings

The extender is preset with a default LAN IP 192.168.0.254, with which you can log in to
the web management page. The LAN IP address, together with the Subnet Mask, also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkrepeater.net, and log in with the password you set for the extender.
2. Go to Settings > Network.
3. Select Use the following IP
4. Enter a new IP Address as needed and leave the
5. Enter the gateway that is in the same subnet as the IP address. The gateway is usually
the LAN IP address of your router.
6. Enter the DNS IP address provided by your ISP.
> Extended Network.
Enable checkbox. In this case, all the wireless settings
> Extended Network.
Extended 2.4GHz SSID
> Extended Network.
address.
Customize Your Network
or click Copy Host SSID. The value is
Subnet Mask as the default settings .
28