Change Lan Settings - TP-Link RE200 User Manual

Chapter 5
2. Extended networks are enabled by default. If you want to disable the wireless function
of a certain band, just clear the
of this band will be invalid.
3. Click Save.
• To change the wireless network name (SSID):
1. Go to
2. Create a new SSID in
case-sensitive.
3. Click Save.
Note:
If you have changed the wireless settings via a wireless device, you will be disconnected after the settings are applied.
Please write down the new SSID for future use.
• To hide the SSID of the extended network:
1. Go to
2. Select
wireless devices scan for local wireless networks. You need to manually enter the
SSID to join the network.
3. Click Save.
5 3
The extender is preset with a default LAN IP 192.168.0.254, with which you can log in to
the web management page. The LAN IP address, together with the Subnet Mask, also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set
for the extender.
2. Go to
3. Select
4. Enter a new
5. Enter the
is usually the LAN IP address of your extender.
6. Leave the
Downloaded from ManualsNet.com
Settings > Wireless > Extended
Extended 2.4GHz SSID
Settings > Wireless > Extended
Hide SSID broadcast, and the corresponding SSID will not be displayed when

Change LAN Settings

Settings > Network.
Use the following IP address.
IP Address as needed and leave the
Default Gateway that is in the same subnet as the IP Address. The gateway
Primary DNS and Secondary DNS
search engine
Enable checkbox. In this case, all the wireless settings
Network.
or click
Network.
Subnet Mask
addresses as the default settings.
Customize Your Network
Copy Host SSID. The value is
as the default settings.
28