Black & Decker KP600 Manual page 5

A Specific Rules: Polishers
• Always wear eye protection.
• Be sure bonnet is snugly installed on pad.
• Keep hands and fingers away from rotating
bonnet.
• Before turning the switch to the "ON" (I)
position, be sure the pad is free to revolve
harmlessly.
• Inspect the bonnet frequently for wear, dirt or
imbedded debris.
CAUTION: Do not allow the power cord to contact
the rotating bonnet as it may become quickly
entangled around it. If this occurs, turn tool OFF
("O" position) and unplug the power cord before
attempting to untangle the cord. If the cord is
damaged, have it repaired or replaced at your local
tool repair station.
• Never use a damaged or torn bonnet.
• Wear proper clothing, short sleeves, nothing
too loose or bulky, such as shop coat, etc.
• Do not turn tool on unless the polishing bonnet
is against surface being polished.
• Be extremely careful when polishing around
sharp or protruding objects on the car body.
CAUTION: Do not use abrasive or rubbing
compounds. The abrasive nature of these products
can damage painted surfaces.
The label on your tool may
include the following symbols.
V volts
A Amperes
Hz Hertz
W Watts
Min. Minutes
Alternating current
Direct current
n No load speed
o
Class II Construction
Earthing terminal
Safety alert symbol
.../min Revolutions or reciprocation
per minute
Descriptions (Fig. A)
1. Pad
2. Front handle
3. On/off switch
4. End handle
5. Foam applicator bonnet
6. Wool bonnet
ENGLISH
5