Q200・0-T800 (Flash P.c. Board Assy.・Power P.c. Board Assy.) - Pentax ist D Service Manual

⑫ Arrange the lead wires for CE marking as shown in the figure below.
7. 0-Q200・0-T800 (Flash P.C. Board assy.・Power P.C. Board assy.)
① Pass T905 (Power supply cable) through between the main plate and bottom plate.
② 0-T800
③ CNL-D1.7x2.5 (2pcs.)
④ Solder 4 lands.
②
⑤ A4, 0-Q200
T905
①
⑤
③
④
⑥
⑥ CNL-D1.7x2.5 (2pcs.)
⑦ Connect the flexible board of T100 to the connector terminal of 0-T800.
⑧ Stick BT (25x10) on the flexible board and main capacitor.
⑦
⑨ Solder 2 lead wires. (Red: T800, Black: T900)
⑨
⑧
76180 EM -29/73-