Processor Safety Inspection - IBM 3907 Safety Inspection

Processor safety inspection

Safety inspection is performed on all power cords.
Attention: Read the following notices before beginning:
DANGER:
Overloading a branch circuit is potentially a fire hazard and a shock hazard under
certain conditions. To avoid these hazards, ensure that your system electrical requirements do not
exceed branch circuit protection requirements. Refer to the information that is provided with your
device or the power rating label for electrical specifications. (D002)
DANGER:
If the receptacle has a metal shell, do not touch the shell until you have completed the
voltage and grounding checks. Improper wiring or grounding could place dangerous voltage on the
metal shell. If any of the conditions are not as described,
impedance conditions are corrected before proceeding. (D003)
DANGER:
An electrical outlet that is not correctly wired could place hazardous voltage on the
metal parts of the system or the devices that attach to the system. It is the responsibility of the
customer to ensure that the outlet is correctly wired and grounded to prevent an electrical shock.
(D004)
DANGER:
Heavy equipment — personal injury or equipment damage might result if mishandled.
(D006)
DANGER:
Arc Flash/Arc Blast hazard when disconnected with power on. Turn off power before
disconnecting. (L015)
CAUTION: The doors and covers to the product are to be closed at all times except for service by
trained service personnel. All covers must be replaced and doors locked at the conclusion of the
service operation. (C013)
CAUTION:
Ensure the building power circuit breakers are turned off BEFORE you connect the
power cord or cords to the building power. (C023)
：
，
：
，
：
：
—
：
1-2
3907 Safety Inspection
。
，
。
。(D003)
，
，
， /
STOP . Ensure the improper voltage or
。
，
， 。
。 (D004)
。
(D006)
。 ，
，
。
(D002)
。
。
。 (L015)