Advertisement
Item Description
already listed as a separate item above)
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components and
materials requiring selective treatment can be removed.
Tool Description
screw driver
tear down stick
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1.
Remove base screws 7pcs
2.
Disassemble base cover from the unit.(rear side use tear down stick)
3.
Take off 4 pcs of screws which fastening battery to Top_assy. and then disassembly the Battery.
4. Remove HDD and HDD cable.(3 screws)
5. Remove KB BL FPC, KB MEM, TP FFC, LCD cable's MB side, Antenna cable's MB side, DB to MB FFC, speaker
cable.
6. Remove 2 pcs of screws and disassemble DB.
7. Remove 8 pcs of screws and disassemble thermal module.
8. Losse 5pcs screws and remove fan cables and 2 fans.
9. Remove 1 pcs screw and disassemble Wlan module from MB.
10. Remove 1 pcs screw and disassemble SSD module from MB.
11. Remove RAM module from MB.
12. Remove DC -in cable, DB to MB FFC from MB.
13. Loose 5pcs screws whiching fastening MB on top_assy and take MB off from top-assy.
14. Remove 2 pcs screw and Disassemble speaker R and L from top-assy.
15. Loose 3pcs screws whiching fastening TP support on top-assy and take off TP support BKT from top-assy.
16. Loose 3pcs screws whiching fastening TP and TP holder assy and take this assy from top-assy.
17. Remove 6pcs of screws and disassemble the display unit from top-assy.(The LCD must open to max angle for
disassemble)
18. Disassemble LCD bezel from display unit.
19. Tear off the 2 pcs reworkable tape from LCD upper side. and take it off from LCD cover. Before removing LCD
module, separate LCD cable from LCD module.
EL-MF877-00
Template Revision C
Last revalidation date 09-May-2018
Notes
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
HPI instructions for this template are available at
EL-MF877-01
Quantity of
items
included in
product
0
0
0
0
Tool Size (if
applicable)
#1
Page 2
Advertisement
