Preventative Maintenance; Troubleshooting; Warranty - Napa 791-6022 Operating Manual & Parts List

LOWERING A MOTORCYCLE OR ATV:
1. Make sure vehicle is properly balanced on lift before removing any additional support equipment.
2. Have one person grab the handle bars of the vehicle in preparation for its lowering and eventual removal from the lift.
3. Follow step 3 under GENERAL INSTRUCTIONS to lower the load.
4. While one person is still stabilizing the motorcycle in a vertical position, the other person should remove the tie down's from the motorcycle and tie
down loops on the lift rails. The motorcycle's kickstand should be pointed down and ready to make contact with the ground. After the tie downs
are removed, lower the motorcycle all the way to the ground so the lift rails clear the motorcycle frame.
5. Slide the lift out from underneath the vehicle.

PREVENTATIVE MAINTENANCE

This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to potential personal
injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the lift in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive dust, or any
other harmful elements. The jack must be cleaned of water, snow, sand, grit, oil, grease or other foreign matter before using.
2. Lubricate all moving parts and joints monthly with the exception of the hydraulic jack. Use a waterproof lubricating grease.
3. Visual inspection should be made before each use of the lift, checking for leaking hydraulic fluid and damaged, loose or missing parts.
Each lift must be inspected by a manufacturer's repair facility immediately, if subjected to an abnormal load or shock. Any lift which
appears to be damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED FROM SERVICE until
necessary repairs are made by a manufacturer's authorized repair facility. It is recommended that an annual inspection of the lift be made
by a manufacturer's authorized repair facility and that any defective parts, decals or warning labels be replaced with manufacturer's
specified parts.
A list of authorized repair facilities is available from the manufacturer.
4. It should not be necessary to refill or top off the reservoir with hydraulic fluid unless there is an external leak. An external leak requires
immediate repair which must be performed in a dirt-free environment by an authorized service center.
5. Every jack owner is responsible for keeping the jack labels clean and readable. Use a mild soap solution to wash external surfaces of
the jack but not any moving hydraulic components.

TROUBLESHOOTING

PROBLEM
1. Unit will not lift rated load.
2. Unit will not sustain rated load or feels "spongy" under rated load.
3. Unit will not lift to full height.
4. Unit still does not operate.

WARRANTY

Please contact your local NAPA Auto Parts Store for details on warranty.
791-6022
OPERATING MANUAL & PARTS LIST FOR 791-6022
ACTION
Purge air from hydraulic system by following procedure under SETUP.
Purge air from hydraulic system as above.
Purge air from hydraulic system as above.
For a complete list of authorized hydraulic repair centers please visit
www.toolwarrantyrepair.com.
4 rev. 03/14/17