Getting Started - Initial Set Up - Technika 40-260 User Manual

Getting Started - Initial Set Up

GETTING STARTED - INITIAL SET UP
1) Using the RF cable supplied, connect the TV
to the TV Aerial wall socket (Fig A)
3) Switch on the television using the
power on/off switch located on the side
of the TV.
5) You will now be welcomed with the initial
set-up screen.
If it does not appear, on the remote control,
please press [MENU] then 8-8-8-8 and the
menu will appear.
Press OK on the remote control and follow
the steps to begin tuning.
If you are missing channels, the reason for this is likely to be signal strength, you should
consider connecting signal booster and re-tuning the TV.
Tip: If the TV fi nds some, but not all, of the Digital channels, the TV is functioning correctly but the
signal being received is not strong enough. (The signal strength needs to be above 85% - you can see the
signal strength the TV is receiving when you change channels/ programmes) you will need to increase
the signal reception in order to receive all of the channels available. The most economical way to do
this is by purchasing and connecting a 'signal booster' in between the TV and the TV aerial socket. If this
does not solve the problem, you will need to upgrade the TV aerial to a digital hi-gain compatible aerial
IMPORTANT NOTE. Occasionally we may release new software/firmware
upgrades/enhancements for this television. Please check the 'firmware
Technika 40 LED.indd Sec1:11 Technika 40 LED.indd Sec1:11
2) Connect the power cable to the Electrical
outlet (Fig B)
Fig A
4) Insert the batteries supplied into the
Remote control and press the Standby
button to power on the TV
Power on/off
upgrade' section of the website regularly.
Fig B
OFF
DISPL
PICTURE
PRESETS
AUDIO LANG
6) Once tuning has fi nished the following
screen will appear.
SLEEP
SOUND
SUBTITLE
ASPECT FREEZE
11 11
25/02/2010 17:37:42 25/02/2010 17:37:42