Cassette Tapes - Technics SC-EH560 Operating Instructions Manual

1
DECK 1/2
H/I
1
EOPEN
2
DOLBY NR
3
REV MODE
4
5
VOLUME
UP
DOWN
A
DECK 1/2
18
RQT5355
4 2 3 1
@
5
Forward side
Tape facing down
Î NR
1
1 Î NR
Tape direction
2
Î NR
Deck in use

Cassette tapes

Preparation:
Press [ /I] to turn the unit on.
1
Press [ OPEN] on deck 1 or deck 2
and insert the cassette.
2
Press [DOLBY NR] to select Dolby NR
on or off.
(" NR" appears)
( "Dolby noise reduction" page 19)
3
Press [REV MODE] to select the re-
verse mode.
Each time you press the button:
: One side is played.
: Both sides are played.
: Both sides are played 8 times each.
4
Press [ ]
(reverse side)
Play begins and the indicator changes to green.
5
Adjust the volume.
To stop the tape
Press [ ].
[A] To change the deck to be used
Press [DECK 1/2] to select the deck you want to play.
To listen to 2 tapes consecutively
Insert a tape into each deck and select "
played 8 times each.
Cassette tape selection and care
The unit can correctly play the following types. It identifies the type
automatically.
Normal position/TYPE I
High position/TYPE II
Metal position/TYPE IV
Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
Tape slack can get caught up in the mechanism and should be tak-
en up before the tape is played.
Endless tapes can get caught up in the deck's moving parts if used
incorrectly. Use tapes appropriate to this unit's auto-reverse mech-
anism.
or [ ] .
(forward side)
". Both tapes will be