Programming the remote operation ID
The remote operation ID is used to access your answering device and listen to your messages in common
memory.
Choose any 3-digit number except a number using digits 0 or 7.
Make sure that the first 2-digits of the remote operation ID are different from the junk mail prohibitor ID (p. 41)
and the mailbox password (p. 50).
Press (MENU).
1
K
A@
2
Press
, then
Press (START/SET).
3
4
Enter the desired number.
Press (START/SET).
5
Press (MENU).
6
Answering Device Remote Operation
1. Call your unit.
2. Enter the remote operation ID
∆∆∆ during the greeting
message.
3. Press the remote command key
(refer to the right) within 4
seconds.
or
Wait for 4 seconds. All the
recorded messages will be played
back.
56
SYSTEM SET UP
.
REMOTE ANS ID
ID=111
Key
Remote Command
`
Skips the greeting message
A
Repeats a message
B
Skips a message
D
New message playback
E
All message playback
F
Room monitor
G
Re-records a greeting message
I
Stops re-recording of a
greeting message
JD
Erases a specific message
JE
Erases all messages
H`
Changes to the TEL mode
HA
Pager alert for ANS—ON
HB
Pager alert for ANS—OFF
(START/SET)
Dial keypad
(MENU)