Introduction; Important Precautions; Parts Included; Tools And Materials Required For Installation - Pentair LINEGUARD UF-100 Manual

4.3.2.5 setting the volume flush ____________________________________________________14
4.3.2.6 setting the flux flush _______________________________________________________14
4.3.2.7 setting an overruling flush __________________________________________________15
4.3.3 setting the alarm _______________________________________________________________15
4.3.3.1 setting the time alarm ______________________________________________________15
4.3.3.2 setting the volume alarm ___________________________________________________16
4.3.3.3 setting the flux alarm ______________________________________________________16
4.3.4 start-up program _______________________________________________________________16
4.3.5 Factory default settings __________________________________________________________17
5 Maintenance _________________________________________________________________ 18
5.1 General inspection ___________________________________________________________________18
5.2 testing and replacing the modules ______________________________________________________18
5.2.1 Integrity testing modules _________________________________________________________18
5.2.2 timing ________________________________________________________________________18
5.2.3 Draining the system _____________________________________________________________19
5.2.4 Dismounting the used modules ___________________________________________________19
5.2.5 Mounting the module(s) __________________________________________________________19
5.3 control Unit – optimizing the settings ___________________________________________________20
6 Dimensions _________________________________________________________________ 21
7 clearances __________________________________________________________________ 22
8 Piping schematics _____________________________________________________________ 23
9 technical Information __________________________________________________________ 24
10 Limitation of warranty and liability _______________________________________________ 25
EN

1 INtRoDUctIoN

thank you for choosing a LineGuard UF-100 water filtration system. please refer to the product datasheet for
details on performance, conditions of use, and storage and handling of this product.
the LineGuard has been specifically designed to remove viruses, bacteria, cysts and protozoa such as
cryptosporidium, Giardia, and Legionella from your drinking water, while allowing healthy, natural minerals
to pass through. It will also eliminate any turbidity from your drinking and shower water.

1.1 Important precautions

1. the LineGuard system is intended for indoor use only.
2. the LineGuard system is only suitable for municipal (treated) water and cold or mixed water lines. the
maximum permitted operating temperature is 50 ˚c/122 ˚F.
3. the maximum operating pressure of the filter system is 4 bar/58 psi. It is recommended to install a
pressure controll valve and a pressure relief valve that relieves water pressure above 4 bar/58 psi to the
drain of the system. please check with your water company or pump supplier for information on the
existing water pressure.
4. If the LineGuard is mounted in a water system already in use, please make sure to disinfect the piping
after the filter system.
5. protect against freezing after first use.
6. Handle with care, do not expose to shocks.
7. please check your national plumbing codes and ensure that you follow those guidelines when installing
the water filtration system.
8. Make sure the filtration system is properly connected in the water system by closely following the
instructions in this manual.
9. the room where the LineGuard is installed should be provide with an water barrier and drain.

1.2 Parts included

• LineGuard (frame and control unit)
• Membrane modules (2 pcs)

1.3 tools and materials required for installation

• Hexagon key 4 mm
• Hexagon key 5 mm
1
EN