Safety And Operating Decals - Generac Power Systems MLT4200IF4 Owner's Manual

Safety and Operating Decals

See Figure 1-1 through
numerous safety and operating decals. These decals
provide important operating instructions and warn of
dangers and hazards. The following diagrams illustrate
decal locations and descriptions.
Replace any missing or hard-to-read decals and use care
when washing or cleaning the unit.
ID
1 Danger–Lower Tower Before Tilting Mast
2 Lift Points
3 Do Not Remove Bolt
4 Crushing Hazard
5 Secure Mast Before Lifting or Towing
6 Tie-Down Point
7 Danger–Electrocution, Consult Manual
8 Warning–Tipping Hazard
9 Instruction–Align Before Tilting Mast Down
10 Danger–Secure Mast
11 Grounding Stud
12 Receptacle Panel Circuit Breaker Locations
13 Warning–Crushing Hazard
14 Warning–Ultraviolet Radiation
15 Warning–High Winds and Electrical Storms
16 Instructions–Set Up
17 Instructions–Starting and Stopping the Generator
18 Warning–Moving Parts and Hot Surface
19 Consult Manual
20 Instruction–Disconnect Battery Before Servicing
21 Remote Start Terminal Locations
22 Danger–High Voltage, Consult Manual
23 Danger–Overhead Power Lines
24 Use Caution When Raising or Lowering Mast
25 Instruction–Towing Instructions
26 Primary Filter
27 Secondary Filter
28 High Voltage
Owner's Manual for MLT4200IF4 Light Tower
Figure 1-3. This unit features
Description
Safety Rules & General Information
Danger–Diesel Fuel, Asphyxiation, No Open
29
Flames, Consult Manual
30 Ultra Low Sulfur Fuel Only
31 Warning–Radiator Is Hot During Operation
32 Warning–Moving Parts, Hot Surface
33 Warning–Hot Surface
7