Oregon CS1200-092 Original Instruction Manual page 19

PRUNING
CAUTION: Falling limbs may bounce or
"spring back" after they hit the ground so
it is essential to keep the ground clear to
provide multiple retreat paths. Clear the
work area and wear head protection.
Pruning is removing dead or overgrown
branches to maintain plant health.
• Plan retreat paths before beginning to cut,
and make sure there are no obstructions.
Always know how to get out of the way of
falling branches.
• Make sure bystanders or helpers are a safe
distance from falling branches. Bystanders or
helpers should not stand directly in front of or
behind the operator. See Fig. .
• Maintain solid footing and hold the chainsaw
firmly with both hands. Do not overreach.
Never climb a tree or ladder to reach high
limbs.
• Secure any branches that might be hazardous.
• Use proper auxiliary equipment.
• Prune lower limbs before pruning higher ones.
• Allow the saw chain to achieve full speed
before cutting.
• Apply light pressure to the branch.
• For long limbs (Fig.
first ( ) to relieve pressure from the limb, then
prune closer to the trunk ( ).
FIG. 20
(1)
Chainsaw Model CS1200-092
Operating the Chainsaw
), cut the end of the limb
(2)
• Thick limbs (greater than
diameter) can splinter or pinch the chain when
making a single cut from the top. To avoid
pinching or splintering, first make one shallow
relief cut on the bottom surface of the limb ( ),
then cut the limb all of the way through from
the top of the limb ( ) to match the bottom
cut (Fig. ).
FIG. 21
(2)
(1)
• After most of the limb has been removed,
make one smooth cut near the trunk (Fig.
FIG. 22
cm ( inch) in
).
19