Defects And Malfunctions; Transport And Storage; Technical Data; Cleaning And Maintenance - Tunturi FitCycle 50i User Manual

English
Body fat mode error codes
- *E-1
There is no heart rate signal input detected.
- *E-4
Occurs when FAT% and BMI result is below 5 or
exceeds 50.
Trouble shooting:
- When the display of LCD is dim, it means the
batteries need to be changed.
- If there is no signal when you pedal, please check if
the cable is well connected.
NOTE
• When stop training for 4 minutes, the main
screen will be off.
• If the computer displays abnormally, please re-
install the transformer and try again.
Bluetooth & APP
- This console can connect with an APP on a smart
device by Bluetooth.
- Once console is connected to a smart device via
Bluetooth, the console will power off.
NOTE
• Tunturi only provides the option to connect
your fintess console throughout a blue tooth
connection. Therefore Tunturi cannot be held
resposible for damage, or malfunctioning of
products other than Tunturi products.
Console connects best with:
"Fit Hi Way"
Developed by: Chang yow.
Search in App store (iOS) for : fit hi way
Search in Play store (Android) for : Fit Hi Way
"Kinomap Fitness
Developed by: Kinomap.
Search in App store (iOS) for : Kinomap fitness
Search in Play store (Android) for : Kinomap fitness

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent cloth
after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual parts can occur in the
equipment. In most cases, it will be sufficient to replace
the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial number of
the equipment to the dealer. State the nature of the
problem, conditions of use and purchase date.

Transport and storage

WARNING
• Carry and move the equipment with at least two
persons.
• Remain standing in front of the equipment
on each side and take a sturdy grip at the
handlebars. Tilt the front of the equipment
so as to lift the rear of the equipment on the
wheels. Move the equipment and carefully put
the equipment down. Place the equipment on a
protective base to prevent damage to the floor
surface.
• Move the equipment carefully over uneven
surfaces. Do not move the equipment upstairs
using the wheels, but carry the equipment by the
handlebars.
• Store the equipment in a dry place with as little
temperature variation as possible.

Technical data

Parameter
Length
Width
2 4
Unit of Value
measurement
cm 101
inch 39.8
cm
inch 20.5
52