Table of Contents
Advertisement
Front Panel
1 2
3
4
5
-10DB
IN
FM TRAP
0DB
OUT
VHF/FM
SEPARATE
-10DB
ATTENUATOR
COMBINED
0DB
INPUT
-10DB
ATTENUATOR
UHF OR
0DB
COMBINED
8
9
UHF or Combined: Connect UHF or
1.
UHF/VHF antenna to this port.
2.
VHF/FM:
Connect VHF antenna to this port
3.
Separate or Combined:
If using separate VHF and UHF antennas, position
slide switch on "Separate". If using UHF/VHF broad-
band antenna, position slide switch on "Combined"
4.
-10 dB:
Provides 10 dB attenuation to low-band input.
5.
FM Trap:
Provides blocking of FM signal if required.
6.
Gain Adjust:
Potentiometer provides for R.F. low-band
gain adjustment
7.
Tilt:
Potentiometer provides for low-band slope adjustment
8.
-10 dB:
Provides 10 dB attenuation to hi-band input.
9.
-10 dB:
Provides 10 dB attenuation to uhf-band input.
PICO MACOM INC.
12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 (800) 421-6511 • FAX (818) 834-7197
All manuals and user guides at all-guides.com
F E A T U R E S
6
7
LO BAND
GAIN
TILT
HI BAND
GAIN
TILT
UHF
GAIN
10
11
12
u
pec
™
•
®
UHF/VHF/FM
DISTRIBUTION AMPLIFIER
MODEL TA-52
UHF/VHF OUTPUT
PL
MONITOR-20DB
14
13
15
10.
Gain Adjust:
Potentiometer provides for R.F. hi-band gain adjustment
11.
Gain Adjust:
Potentiometer provides for R.F. uhf-band gain adjustment
12.
Tilt:
Potentiometer provides for hi-band slope adjustment
13.
UHF/VHF Output:
Connect this port to distribution system
14.
Monitor -20 dB:
Used to monitor output signal
15.
Power LED:
Indicates when amplifier is on.
16.
Fuse:
Replace with 1 amp 250 volt fuse.
17.
On/Off:
Power on or off switch
18.
Power Cable:
The three prong type power plug connects to a 120 Vac,
60 Hz electrical outlet.
CAUTION
DO NOT REMOVE SCREWS
117V
1A
ON
40W
FUSE
16
17
18
4
Advertisement
Table of Contents
