Remote Controller (Bottom Panel) - Tascam CD-X1700 Owner's Manual

English
x IN and OUT keys
Use these keys to record and clear the sampled
sound. When you have recorded the sample, these
keys will light. Start and stop sample playback
using these keys. (∑ page 17)
Pressing and holding the IN key then using the Jog
wheel controls the sampler output level.
c LOOP and REV LEDs
Indicates the sampler playback mode. (∑ pages 17
- 18)
v KEY ORIG / KEY key
Turns the KEY ORIGINAL function on and off.
(∑ page 14)
Sets the key control value. (∑ page 15)

2-4. Remote Controller (Bottom Panel)

, Remote Connector
Connect this to the REMOTE connector on the rear
panel of the main unit.
WARNING
... DO NOT use any cable except the cable
supplied with the CD-X1700.
10
TASCAM CD-X1700 DUAL CD PLAYER
2. Functions and Controls
b TEMPO / BANK key
Selects the tempo range, either +/-8, 16, 32, 100 or
0%.
Selects the track memory bank from A to E.
(∑ page 18)
n BEND +/ A.RDY, –/A.CUE keys
Use these keys to perform pitch bending.
(∑ page 14)
Turns the AUTO CUE function on and off.
(∑ page 20)
Turns the AUTO READY function on and off.
(∑ page 20)
m TEMPO slider
Changes the playback tempo. (∑ page 14)
... Connect the cable to the CD-X1700 as
shown on the illustration on the rear
panel. If you connect the cable in any
other way, you may damage the CD-
X1700.