Sync Recording (Start); Sync Recording (Stop); Sync All; Sync Off - Tascam CC-222MKII Owner's Manual

5 – Recording CDs—Advanced recording

Sync recording (start)

The conditions under which an input signal is used as
the trigger to start recording in the
modes are:

SYNC 1

• when recording digitally from a DAT deck, a digi-
tal track start signal is detected (the signal level is
ignored):
level
Track start signal
received Start of recording
S_LVL
• when recording digitally from a CD or MD deck, a
digital track start signal is received, and the signal
level subsequently rises above the trigger level:
level
Track start signal
received
S_LVL

Sync recording (stop)

SYNC ALL

In the
SYNC ALL
stops when the input level drops below the trigger
level for more than six seconds.
level
S_LVL
Also note that in this mode, the auto track function is
enabled (see "Automatic track division" on page 31).

SYNC OFF

Automatic synchronized record start
and stop functions are disabled and must be per-
formed manually.
30
TASCAM CC-222MKII Owner's Manual
and
SYNC ALL
time
Start of recording
time
mode, recording
STOP
6 seconds
time
• when recording from any source other than the
ones described above (that is, any digital source
other than DAT, CD or MD, or any analog source),
recording starts when the input signal level exceeds
the trigger level.
Trigger level
level
exceeded
S_LVL
In this last case, if the signal level is already higher
than the trigger level, recording starts immediately.
SYNC 1
In the
SYNC 1
the start of the next track (when the level of the first
track has gone below the trigger level for less than
six seconds and the level of the second track goes
above the trigger level)
level
S_LVL
or
When the input level goes below the trigger level for
more than six seconds (as in the
mode).
Start of recording
time
mode, recording stops at
Recording
Less than stops
six seconds
time
SYNC ALL