Cassette Operations; Playback Operations; Continuous Tape/Cd Playback - Tascam CC-222MKII Owner's Manual

3 – Cassette operations
Note the following when loading tapes:
1 Use your finger or a pencil to turn the cas-
sette's hub and take up any slack tape.

Playback operations

1 With the power on, set the
to the required tape mode.
u Single-sided playback
j One side, then the other side, then stop
p
One side, then the other side, then the first side again,
etc.

Continuous tape/CD playback

1
Load the tape (as described above) to be
played back into the unit. Load the disc (use
the key and load the disc
OPEN/CLOSE
recorded side downwards and close the tray).
2 Press the
CD-TAPE CONT PLAY
3
Press either of the
PLAY
deck, or the PLAY key of the CD deck.
Playback will start on the appropriate unit.
When playback reaches the end of the disc,
or the end of the tape (either one side or two
16
TASCAM CC-222MKII Owner's Manual
switch
REV MODE
key.
keys of the tape
NOTE
Avoid touching the tape. Fingerprints attract dust and
dirt.
2 Press the key to open the cassette
EJECT
compartment door.
3 Load the cassette tape with its open edge fac-
ing down.
4 Gently close the compartment door.
NOTE
*Notes:
The cassette holder cannot be opened during recording
or playback.
If the power has been switched off during play or
recording, ejecting the cassette may be impossible. In
such a case, switch the power on and press the EJECT
key again.
2 Load a pre-recorded cassette with its open
edge facing down and side A facing toward
you.
3 Set the Dolby NR system on or off.
4 Press either key to start playback.
PLAY
5
Adjust the volume with the amplifier's vol-
ume control.
6
To stop playback, press the
sides, as determined by the
ting), playback starts on the other unit.
Media (tape or disc) can be changed in the unit that is
not playing.
NOTE
The cassette deck and CD deck can be used to play back
through different outputs, or the LINE OUTPUTS 2
jacks can be used for both disc and tape playback. How-
ever, note that if both are playing, the cassette takes
priority (the disc will not be heard through these out-
puts). Disc playback is always through the LINE
OUTPUTS 1 jacks.
key.
STOP
set-
REV MODE