Establishing A Communications Link - Targus Rechargeable 5-Button Wireless Mouse User Manual

Targus Rechargeable 5-Button Wireless Mouse

Establishing a Communications Link

The mouse has 256 identification codes that allow the mouse and its
receiver to operate without interference from other radio frequency
devices.
After your computer detects the USB receiver and the driver software
is installed, you must establish a communications link between the
mouse and its receiver BEFORE you can use the mouse. To establish
this link, you need to set the identification code so that the mouse
works properly.
NOTE: Make sure that your computer is turned on and
has detected the USB receiver before you establish a
communications link.
1 Press and release the connection button on the receiver.
The USB connector rotates 90 degrees to facilitate easy
connection to your computer.
2 The receiver's red status light blinks when the receiver is
activated.
Connection
button
Status light
Bottom of mouse
Receiver
Connection button
8