Table of Contents
Advertisement
Body & Accessories
Programming New Card Keys
NOTE: Do not program card keys while WDS or any other computer devices are in the
vehicle. Make sure all card keys are operational and have good batteries.
NOTE: Auxiliary keys have to be programmed separately as ignition keys.
With Two or More Card Keys
•
If two or more registered card keys are available, additional keys can be programmed
without the use of WDS. A maximum of six card keys can be programmed.
1.
Bring the two registered card keys (key 1 and key 2), and the card keys to be
programmed into the vehicle and close all doors.
2.
Insert auxiliary key in ignition lock.
NOTE: The procedure below must be completed up to step six within 30 seconds of
inserting the auxiliary key in the ignition lock.
3.
Turn the ignition ON.
4.
Push the UNLOCK button on card key 1 once.
5.
Push the UNLOCK button on card key 2 once.
6.
Turn ignition switch to ACC then back to ON three times.
7.
Open and close the driver's door three times. The door lock actuators will lock once,
then unlock to confirm that key programming mode is active.
8.
Push the UNLOCK button on the card key to be programmed twice. The door lock
actuators will lock once, then unlock to confirm that programming was successful.
9.
To program additional card keys, remove the auxiliary key from the ignition lock and
repeat the above process again from the start.
With WDS
1.
Establish communication between WDS and the vehicle.
2.
Select the option Toolbox→Body→Security→PATS Functions.
3.
Carry out the security access procedure (read out the WDS outcode, and input the
corresponding incode).
4.
Select the option Card Key Programming. The door lock actuators will lock once, then
unlock to confirm that key programming mode is active.
5.
Push the UNLOCK button on the card key to be programmed twice. The door lock
actuators will lock once, then unlock to confirm that programming was successful.
6.
To program additional card keys, remove the auxiliary key from the ignition and repeat
the above process again from step 4.
Service Training Mazda6 Facelift
Accessories
09-33
Advertisement
Chapters
Table of Contents
