Table of Contents
Advertisement
Configure the Gateway
TANDBERG Gateway
Dial In Max. Bandwidth
The call rate (bandwidth) for incoming calls will automatically be determined by the endpoint. However, you can
use this setting to restrict the call rate for incoming DID/TCS-4 calls.
Calls above the Dial In Max. Bandwidth will be downspeeded
D
.
NOTE
REQUIRE SUPPORT OF
OWNSPEEDING ON THE ENDPOINT
to the call rate specified in Dial In Max. Bandwidth.
Calls below the Dial In Max. Bandwidth will be connected at the requested call rate.
Dial In Number
All incoming calls received on this number will use the IVR/TCS-4 service.
2nd Dial In Number
This is the second number used for the 2x64k (H.221) dial in method. Most modern equipment used the default
BONDING method and don't need the configuration of this number.
Allow Incoming Phonecalls
Incoming phonecalls can be disabled.
Hotline
ISDN Number
All incoming calls received on this number will be forwarded to the IP endpoint specified in 'H.323 E.164 Alias'
field.
H.323 E.164 Alias
All incoming calls received to the Hotline ISDN number will be forwarded to this H.323 Alias.
Max. Bandwidth
The call rate for incoming calls will automatically be determined by the endpoint. However, you can use this
setting to restrict the call rate for incoming Hotline calls.
NOTE
D
.
REQUIRE SUPPORT OF
OWNSPEEDING ON THE ENDPOINT
52
Advertisement
Table of Contents
