Software Setup; Hardware Veri Cation At-Gpib/Tnt - HP 84125C User Manual

4. Shut down Windows NT and turn o the computer.
5. Remove the computer cover and install the GPIB interface card. If
possible, avoid using the rst or last slot as it is dicult to connect
the GPIB interface cable with the card in either of these locations.
6. Turn on the computer and start Windows NT.

Software Setup

After installation of the NI-488.2 software, the windows group
NI-488.2 GPIB Software
operation of the hardware and software installation, you will need to
perform the following steps.
1. From the Windows NT
then double-click on the GPIB icon.
2. In the GPIB Con guration window, with the GPIB0 board
highlighted, click on the
3. In the GPIB0 (AT-GPIB/TNT) window, click on the DMA Channel
drop-down list box and set the DMA to the value set on the card in
step 1 of \Hardware Setup and Installation".
4. Set the Base I/O Address and IRQ to the same values set on the
card in steps 2 and 3 of \Hardware Setup and Installation".
OK
5. Click on the button.
OK
6. Click on the button in the GPIB Con guration window to exit
the GPIB application.
Hardware Veri cation AT-GPIB/TNT
It is important to test your hardware con guration before attempting
to use the AT-GPIB interface. Use the following procedure to verify
correct operation.
1. From the Windows NT
for Windows NT, Diagnostic
2. In the Diagnostic window, click on the
3. When the test is complete, click on the
software diagnostic test.
will be created. Prior to verifying proper
Start Settings, Control Panel
menu, select
Con gure
button.
Start Programs, NI-488.2M
menu, select
.
Test All
Exit
Using the HP 84125C Utility 7-9
button.
button to exit the
,