Table of Contents
Advertisement
Setting Up HP-IB Interface for Windows NT 4.0
7-4 Using the HP 84125C Utility
3. From the Run dialog box, select the CD ROM drive. Use the
Browse button if you do not know the location of the CD ROM
drive.
Setup.exe
4. Select
5. From the HP/IO Libraries Installation window, select
95
.
6. Verify the SICL and VTL les locations then press
7. When the installation is complete, the message \Installation
Succeeded" will be displayed. Click
8. To complete the con guration, select
LIBRARIES
I O Con g
,
9. From the Con gured Interfaces area, verify that the HPIB is set
to 7. This value will need to be set in the GPIB Con guration of
the HP 84125C Utility. Refer to \GPIB Con guration Window" for
more information.
10. From the Available Interface Types area, select
HP-IB
then click
11. Make any necessary changes then click
12. When the driver is successfully installed, recycle the power and
restart Windows 95.
Hardware Veri cation
Start
Settings
1. Select
,
2. From the Control Panel window, select the
3. From the System Properties window, select
HP-IB
4. Verify that
There is no diagnostic test for the HP-IB card.
The HP-IB interface card (HP 82341C) can be con gured and installed
using the following three steps.
Hardware Installation (HP 82341C)
1. Shut down Windows NT and turn o the computer.
2. Remove the computer cover and install the HP-IB interface card. If
possible, avoid using the rst or last slots as it is dicult to connect
the GPIB interface cable with the card in either of these locations.
Use the default switch settings on the HP 82341C card.
3. Turn on the computer to start Windows NT.
Software Installation
1. Place the HP/IO Libraries for Instrument control compact disc
(CD) into the CD drive of your computer to load the HP 82341C
software.
to load the driver.
OK
Start
.
Con gure
.
Control Panel
,
.
is listed.
Windows
Install
.
.
Programs
HPI O
,
,
HP 82340/ 82341
OK
.
System
icon.
Device Manager
.
Advertisement
Table of Contents
