Connection; Cst Bus; Interface Description - Bosch PAVIRO Series Operation Manual

26 en | Connection
6

Connection

6.1

CST BUS

Notice!
If the call station is connected to a controller via the CST BUS,
the call station is automatically configured depending on the
set CAN address. The call station is ready to use after a few
seconds.
The cable for connecting the CST BUS must be connected as
shown in the illustration below. Use the supplied strain relief
bracket and two screws to fix the cable.
6.1.1

Interface description

The CST BUS port is used to connect the call station with a
controller. This is an 8-pin RJ-45 port that assigns the power
supply, control interface (CAN bus), and audio interface. The
call station must be connected to the respective wall-mount
2018.04 | 04 | F01U306899
PAVIRO Call Stations
Bosch Security Systems