Electrical current safety information
DANGER:
Electrical current from power, telephone, and communication cables is hazardous.
To avoid shock hazards:
•
Do not use your computer during a lightning storm.
•
Do not connect or disconnect any cables or perform installation, maintenance, or
reconfiguration of this product during an electrical storm.
•
Connect all power cords to properly wired and grounded electrical outlets.
•
Any equipment to which this product will be attached must also be connected to
properly wired and grounded power outlets.
•
When possible, use one hand only to connect or disconnect signal cables.
•
Never turn on any equipment when there is evidence of fire, water, or structural
damage.
•
Disconnect the attached power cords, telecommunications cables, network cables,
and modems before you open the device covers, unless instructed otherwise in the
installation and configuration procedures.
•
Connect and disconnect cables as described in the following table when installing,
moving, or opening covers on this product or attached devices.
To connect:
1. Turn everything OFF.
2. Attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlets.
5. Turn device ON.
To disconnect:
1. Turn everything OFF.
2. Remove power cords from outlets.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
-27-