Fixture Reset; Display; Network - Blizzard Stiletto Ray-Z Manual

Software Version
1.) This menu item will give you information on the currently installed software
versions of Motor, Dimmer, and Network.
Factory
Selecting this menu item allows access to the following calibration options. All of the set
values will be maintained each time the fixture is turned on, and he password must be
entered each time to enable modification of the values.
1.) Password: The password is: 158
2.) Pan/Tilt/Zoom: 0-255 (these default values are 127)
3.) Red/Green/Blue/White: 0-255 (these default values are 255)

Fixture Reset

Selecting this menu item allows access to the following options:
Motor Reset
1.) This function is set to OFF by default. Switching to Run by using the <UP/
DOWN> buttons, then pressing the <CONFIRM> button will reset the Pan, Tilt,
and Zoom motors.
Factory
1.) This function is set to OFF by default. Switching to Run by using the <UP/
DOWN> buttons, then pressing the <CONFIRM> button will reset all values and
functions to the factory default settings.

Display

Selecting this menu item allows access to the following options:
Language
1.) Selects the display language between English and Chinese.
Display Flip
1.) When this selection is set to Normal, the display is in the normal position,
when Reverse is set, the display is rotated by 180°.
Display Mode
1.) When this selection is set to Show, the display will always remain on, when
60s is set, the display will turn off after 60 seconds of inactivity.

Network

This menu item allows you to select the protocols of sACN, Art-Net, KlingNet, and adjust
the settings for Universe, IP Address, and Subnet Mask.
Art-Net/sACN Modes
1.) Navigate the main menu to reach Network, press <CONFIRM>.
2.) Use the <UP/DOWN> buttons to highlight Protocol, press <CONFIRM>.
3.) Now highlight either Art-Net or sACN, and press the <CONFIRM> button.
4.) For Art-Net protocol setting the IP Address value and Subnet Mask is not
required. For sACN protocol, be sure the IP Address set to: 000.000.000.000.
KlingNet Mode
1.) Navigate the main menu to reach Network, press <CONFIRM>.
2.) Use the <UP/DOWN> buttons to highlight KlingNet, press <CONFIRM>.
3.) Now highlight Enable, and press the <CONFIRM> button.
Stiletto™ Ray-Z Manual Rev. A
Page 15
© 2019 Blizzard Lighting, LLC